Up
|
UltraScope Software introduces a family of Windows 95, 98, 2000, NT, and Windows XP applications that connect your GAODS5000 series oscilloscopes to your PC desktop by USB, RS-232 or GPIB (IEEE 488.2). The UltraScope software provides the following control and analysis features: * Use Data Browser to display captured waveforms, data and measurement * Use DSO Controller to control the oscilloscope locally or over the network * Export the waveform by "BMP" format * Save the data into "TXT" or "EXCEL" file for analysis IBM-compatible PC with the following installed * Microsoft Windows 95, 98, NT 4.0, 2000, or Windows XP * 16 MB RAM or greater recommended * CD-ROM drive, 4X or better * Super VGA monitor or better * If you are using UltraScope Software for Oscilloscopes with GPIB communications, you will also need a National Instruments IEEE-488.2 GPIB Interface Card, GPIB driver software (usually included with the GPIB interface card ) and a GPIB cable You must have a GAODS5000 series oscilloscope and the firmware version must be higher or equal to 01.01.33 To connect to PC, the oscilloscope must install USB driver or an extension module with RS-232 or GPIB port You must have a return authorization number to return your product. Please contact support@gaotek.com to obtain an authorization number, which shall be valid for 14 days after issued. This product is covered by a warranty of 12 months. You must have a return authorization number to service your product. Please contact support@gaotek.com to obtain an authorization number. |